[. . . ] ователя Italiano Español Deutsch Nederlands Русский Section 01 02 Before you start Operating this unit Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] W CTRL (subwoofer adjustment) Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the following: Cut-off frequency—Output level—Slope level Rates that can be adjusted will flash. HPF SETTING (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. To cycle between the following: Cut-off frequency—Slope level 3 Turn M. FM STEP (FM tuning step) Normally, the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. 50 (50 kHz)—100 (100 kHz) SP-P/O MODE (rear output and preout setting) English Switching the dimmer setting You can adjust the brightness of illumination. The rear speaker leads output and the RCA output of this unit can be used to connect a full-range speaker or subwoofer. W – Select when there is a fullrange speaker connected to the rear speaker leads output and there is a subwoofer connected to the RCA output. W – Select when there is a subwoofer connected directly to the rear speaker leads output without any auxiliary amp and there is a subwoofer connected to the RCA output. REAR/REAR – Select when there is a fullrange speaker connected to the rear speaker leads output and the RCA output. If there is a full-range speaker connected to the rear speaker leads output and the RCA output is not used, you may select either REAR/SUB. You can also change the dimmer setting by pressing and holding /DIMMER. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. F Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. Note AUX cannot be selected unless the auxiliary setting is turned on. For more details, refer to AUX (auxiliary input) on the previous page. O N ACC position No ACC position Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. [. . . ] Since the CD side of DualDiscs is not physically compatible with the general CD standard, it may not be possible to play the CD side with this unit. Frequent loading and ejecting of a DualDisc may result in scratches on the disc. In some cases, a DualDisc may become stuck in the disc loading slot and will not eject. To prevent this, we recommend you refrain from using DualDisc with this unit. [. . . ]